#Skyrim console delete object how to
#Skyrim console delete object trial

Normally it is flat on the ground (or tilted a bit if you haven't lined yourself up exactly) but sometimes it is half buried. You'll have noticed that when you use aceatme (Base ID), the object is placed at your feet. It's all to do with selecting the object that you want the light effect to centre on. I've learnt a bit more about light placement that alters what I said above a bit and might make light placement easier in some circumstances.

#Skyrim console delete object trial

I placed half a dozen floating cheeses around the room so that I could trial a few light types at once, before committing to putting one over the torch pedestal, because it saves the clart of load, try light, load, try light and so on.Д®dit 2: Amendment to edit, or the second amendment as the Americans might say. Go back and try again if you're not happy. Toggle clipping back on and delete the falling cheese wheel (or whatever you used to locate the light. Select your hovering object and use placeatme (Light's Base Id).ДЇly around the room checking out that the lighting effect is good and causes no problems like flickering, lines through shadows etc. I used a cheese wheel which was perfect for the job.ДЇly back down to where you can see the pedestal and your hovering object andВ repositionВ the object over the centre of theВ pedestal if necessary. Use aceatme (base ID), where base ID is anything reasonably sized. two or three feet was about right for me (60 to 90 cm for modern metric people) The exact height will vary depending what you are trying to illuminate. Type tcl to toggle clipping off.ДЇly up to a position a couple of feet above the torch pedestal. Make sure no item reference is displayed mid screen (click on the same item twice to get shot of any reference that is there).

#Skyrim console delete object how to

If It's any help to people this is what I did wrong and then how to do it right.Д®nterВ the console and target the top of the torch pedestal I've got so far I don't want to give up on the idea now!Д®dit: Problem solved! I was putting the lights in incorrectly.

I've attached a pic of the outside that I'm happy with. I've tried dozens of lights and none of them are anything like as bright.ДЄre there any console commands to increase brightness?ДЄlternatively, is there a way to load my console modified Temple into the creation kit? If I could do that, I could easily (I hope)В add the new lighting effects there. The problem is that the light (BleakFallsDraugrTorch01NS) has been adjusted in Skyhaven temple to make it brighter by far. I even know which light was used in the originalВ sconces and can add it. I can add the torch pillars (6da93) and add the burning coals ((33da4).

It was all going great until I started on the lighting. I'm turning Skyhaven Temple into a player home.